1. Home
  2. Physical Rehabilitation
  4. Long thumb splint

Long thumb splint

Objective
Immobilization of the basal and MCP joint with extension stop for the distal phalanx.
Indications
  • Thumb basal joint arthritis;
  • thumb sprain;
  • tendinitis;
  • arthritis.

Tip: this splint is available as a pre-cut.

Fabrication steps
Starting Position
Recommended products
ORFILIGHT NS
ORFIT CLASSIC
ORFIT NS
AQUAFIT NS
ORFIT COLORS NS
TECNOFIT
Thicknesses mm (inches)
1,6 mm (1/16")
2,0 mm (1/12")
2,4 mm (3/32")
Perforations
Maxi Perforated
Micro Perforated
Micro Plus Perforated
1.

Place the pattern over the radial side of the forearm, covering the thumb completely.

2.

Bring the hand in a vertical position, grasp the uppermost corners and stick them together by pressing them together.

3.

Do the same with the bottom corners, stretching out the length and width of the pattern.

4.

Position and leave to harden.

5.

Finishing:

  • Cut off any surplus material, leave to harden further, and pull open the seam.
  • Slightly warm the edges, bending them so that they do not press against the skin.

Fixation:

  • Close the splint using the 2 short straps at both ends.